Designed a mount to hold a WD19TBS dock to the bottom of a desk. It is designed to slide in from the back with a clip built in to add friction to hold it in place.
Also comes with a similar mount for the power supply (PSU).
The holes are setup for #8 flat head screws.
Features:
Tool-less install/removal of the dock
1/4 in gap on top for airflow
The two sides are separate so it can be printed on a small printer. To print this make sure to flip the design to print the large flat side down. It was modeled differently.
Air vents on the side to allow the dock to ventilate.
